Agri-City Insurance
                                                                                                  
               
M-F: 8:00 AM - 5:00 PM
APPOINTMENTS AVAILABLE
​AFTER HOURS
  • HOME
  • LOCATIONS
    • NORFOLK
    • SCHUYLER
    • COLUMBUS
  • PARTNERS
  • ABOUT US
  • REQUEST A QUOTE
  • INSURANCE PRODUCTS
    • BUSINESS LINES
    • CROP AND HAIL
    • FARM INSURANCE
    • LIFE INSURANCE
    • HEALTH INSURANCE
    • PERSONAL LINES
    • TRUCKING
  • CONTACT US
  • BLOG

Storage and Handling of Compressed Gas Cylinders

5/15/2017

Comments

 
A guest post from Wayne State College Student Tony Gibilisco
Storage and Handling of Compressed Gas Cylinders
 
How do I properly store compressed gas cylinders?
Cylinders should be stored in clearly identified locations, as well as in dry, well ventilated areas that aren’t exposed to heat or the sun. These areas should be out of the way of doorways, aisles, elevators, and stairs. There should be “NO SMOKING” signs in the areas. Cylinders should always be stored upright, no matter if they are full or empty, and they should be secured with a chain or non-conductive belt. The protective caps should always be on when in storage and the valves should always be closed. Oxygen and Fuel gas cylinders should be stored separately and should have a wall or barrier that has a minimum of a half-hour fire rating.
What not to do.
Cylinders should never be used as an electrical ground connection. Cylinders shouldn’t be fastened to a work table as they could become part of an electrical circuit. Do not strike an arc on a cylinder. Never use flames or boiling water to thaw a frozen valve, warm water is acceptable. Cylinders should never be placed or stored in unventilated enclosures such as lockers or cupboards. Cylinders should never be used as rollers or supports for anything. Never tamper with the safety devices. Cylinders should only be used to contain gas that the cylinder was designed to hold. Acetylene cylinders can never be in a horizontal position. Never accept a cylinder that is not properly labeled or marked. Do not angle the cylinder and roll to move them. Do not lift a cylinder by the valve cap, nor use rope or chains or lift with electromagnets. Never drag, slide, or drop a cylinder as it could become a missile. A cylinder should never strike another cylinder violently. Never try to refill a cylinder or try to mix gases in the cylinder.
What do I do with empty or unusable cylinders?
The cylinders should be marked empty or unusable. Return empty cylinders to the supplier. When a cylinder is not in use the regulators should be removed and the protective cap should be put on the cylinder. Keep cylinders and fittings from becoming contaminated with oil, grease or dust. A cylinder should always be labeled, and if it is not properly labeled, the cylinder should never be used.
How do I properly move the cylinders?
Always close cylinder valves. Remove regulators and always tighten the cap on the cylinder before moving. When moving a cylinder, always use a trolley and the cylinder should be chained to the trolley before moving the trolley.  If there is a leaky cylinder, call the supplier immediately and have them remove the cylinder. When cylinders are being transported by vehicle, they should be secured in an upright position.
When do I “crack” the cylinder?
Before attaching the regulator, clean the valve with a clean cloth. “Cracking” a cylinder refers to opening the valve slightly and closing it quickly to blow out dust or dirt from the valve outlet. Always use two hands when doing this and always stand to the side of the valve. Never stand over, in front, or behind the valve outlet. Never “crack” Fuel gas cylinders as it could ignite from friction, heating, or other ignition sources. Never “crack” hydrogen cylinders since the release of compressed hydrogen may ignite by itself.
 

Comments

    Categories

    All
    Partners
    Wayne State College

    Safety Matters

    Our blog will feature posts not only from Agri-City Insurance staff, but also from Wayne State College Students on various topics related to safety, risk management, and loss prevention.

    While we take care to ensure that the information provided is accurate and relevant to the topics, we will use many outside resources and therefore can not guarantee the information provided from other sources.

    Each business is responsible for ensuring their own compliance with OSHA, State, and local regulations.

    The information that is provided by Agri-City is for your use in conjunction with your safety program and is not a replacement for your safety committee, written safety program, or safety training program.

    Be sure to create an online account to utilize additional free videos offered by your insurance carrier.

    Archives

    July 2022
    June 2022
    May 2022
    April 2022
    February 2022
    January 2022
    December 2021
    November 2021
    October 2021
    September 2021
    August 2021
    July 2021
    June 2021
    May 2021
    April 2021
    March 2021
    February 2021
    January 2021
    December 2020
    November 2020
    October 2020
    September 2020
    August 2020
    July 2020
    June 2020
    September 2018
    June 2018
    March 2018
    February 2018
    January 2018
    December 2017
    November 2017
    October 2017
    September 2017
    August 2017
    July 2017
    June 2017
    May 2017
    April 2017
    March 2017
    February 2017
    January 2017
    June 2016
    May 2016
    April 2016

    RSS Feed

Picture
©  AGRI-CITY INSURANCE 
SCHUYLER, COLUMBUS,
AND NORFOLK
THIS AGENCY IS AN EQUAL OPPORTUNITY EMPLOYER.
Columbus Location 
2457 33rd Ave Suite E
Columbus, NE 68601
Phone: (
402) 564-5000
Fax: (402) 564-0441
​Schuyler Location 
220 East 11th Street
Schuyler, NE 68661
Phone: (402) 352-2483
Fax: (402) 352-3366
​​Norfolk Location 
3204 Koenigstein Ave
Norfolk, NE 68701 
Phone: (402) 371-0550
Fax: (402) 371-0565
Picture
Picture